FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

Need Help?

That's what we're here for! The goal of the Rogers Community is to help you find answers on everything Rogers. Can't find what you're looking for? Just ask!
cancel
Showing results for 
Search instead for 
Did you mean: 
Reply
I'm Here A Lot
Posts: 5

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

@RogersDave @Killacammy same issue.  Wired speedtests seem to to cap at about 88meg down.  Used to be over 700meg down.  Get over 250down over 5g.

 

My guess is that modem/router is reading wired connection to be 10/100 not 10/100/1000.  Using same cables rated 5e as on my 3552.

 

On the positive side, my upload speeds have gone up from about 30meg to 40 and the levels are much better.

Highlighted
I'm Here A Lot
Posts: 5

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

Fixed my own issue - DO NOT USE PORT 1.

 

Confirmed that Port 1 - goes green just 10/100.

 

Moving to Port 4, I get yellow connection and much better results.  877 down, ping ms.

 

 

I'm a Reliable Contributor
Posts: 610

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

@User105

 

877 down and how much ping ms?

I Plan to Stick Around
Posts: 28

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

"Fixed my own issue - DO NOT USE PORT 1.

 

Confirmed that Port 1 - goes green just 10/100.

 

Moving to Port 4, I get yellow connection and much better results.  877 down, ping ms."

 

FWIW, using exactly port 1.

940 down.

Also, using two CAT-7 cables, certified up to 10 Gb/sec: one from switch to router, and the second one from router to port 1 of the CODA-4582.

 

Bought here:

http://www.ebay.ca/itm/Dulcet-Inimitable-Cat-7-RJ45-Shielded-LAN-Network-Ethernet-Cable-Internet-Cor...

Network Architect
Network Architect
Posts: 611

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial


@SimplePanda wrote:

@RogersDave - Having done a bit of testing it appears this new modem still suffers from the IPSec performance issues of the previous devices.

 

Site A: Gigabit Ignite connection at my house (new Hitron D3.1 gateway in bridge mode to a Ubiquiti Networks EdgeRouter).

Site B: 100Mbps Beanfield connection (symmetric FTTP) behind a Juniper SRX.

 

Copying files from the office (Beanfield) to the house (Rogers):

 

If I copy something over SSH = 100Mbps (saturates the Beanfield upstream).

If I copy something over IPsec / UDP (NAT-T) = 25Mbps, maximum.

 

Previously the poor IPSec performance was IPv6 / ESP based (same 25Mbps speed limit).

 

Do you still think this is a Hitron firmware issue?


On the Puma 6, this limitation was a chipset issue which I'm still hoping will get resolved. It just keeps being de-prioritized because we are trying to address latency.

 

On the Puma 7, I can't say for sure. It will have to be carefully tested but that will come in January.

 

Dave

Network Architect
Network Architect
Posts: 611

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial


@Killacammy wrote:

@RogersDave have you noticed anything with mine?  The fact that I can only get 11mbps while wired vs 30 mbps via 5g makes absolutely  no sense to me and the speeds have yet to improve at all.  I have switched wires and still nothing.


In both cases, these are very slow speeds and I suspect you are impacted by the 2.4 GHz issue.

 

I can have a look and suggest further action if you send me your MAC address via private message.

 

Dave

I Plan to Stick Around
Posts: 23

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

Hi,

 

I noticed that when someone includes a screenshot of their upstream and downstream signal parameters the signal strength is almost always positive. I checked mine and they are all negative. Is this a problem? 

 

I am on a gigabit internet but my speed never goes more than 550Mbps on a wired connection when I had my previous modem.  I tested today and I only got 104.17 Mbps down and 29.70 Mbps up using the new modem.

 

Modem is at least 6 feet away from the router, I'm connected through port 3 and Wifi on the modem is disabled.

 

http://www.speedtest.net/my-result/5900543977

 

I can't even use the Rogers Speed Check. I get a 'Latency Test Error'.

 

Downstream Overview
Port IDFrequency (MHz)ModulationSignal strength (dBmV)Channel IDSignal noise ratio (dB)
1615000000256QAM-1.6001140.366
2561000000256QAM-1.700238.983
3567000000256QAM-2.300338.983
4573000000256QAM-2.700438.983
5579000000256QAM-2.600538.983
6585000000256QAM-2.400640.366
7591000000256QAM-2.100738.983
8597000000256QAM-1.300840.366
9603000000256QAM-1.900940.366
10609000000256QAM-1.9001040.366
11555000000256QAM-2.100138.983
12621000000256QAM-2.2001238.983
13633000000256QAM-1.9001338.983
14639000000256QAM-1.3001440.366
15645000000256QAM-0.8001540.366
16651000000256QAM-0.4001640.366
17657000000256QAM-0.9001740.366
18663000000256QAM-0.9001840.366
19669000000256QAM-1.0001938.983
20675000000256QAM-1.3002038.983
21681000000256QAM-0.7002140.366
22687000000256QAM-0.6002240.366
23693000000256QAM-0.8002340.366
24699000000256QAM-1.2002440.366
25705000000256QAM-2.1002538.983
26711000000256QAM-2.9002638.983
27717000000256QAM-2.6002738.983
28723000000256QAM-2.9002838.605
29825000000256QAM-2.2002938.605
30831000000256QAM-1.8003040.366
31837000000256QAM-2.1003138.983
32843000000256QAM-2.8003238.983
OFDM Downstream Overview
ReceiverFFT typeSubcarr 0 Frequency(MHz)PLC lockedNCP lockedMDC1 lockedPLC power(dBmv)
0NANANONONONA
14K275600000YESYESYES-1.599998
Upstream Overview
Port IDFrequency (MHz)ModulationSignal strength (dBmV)Channel IDBandwidth
130596000ATDMA - 64QAM34.25016400000
238596000ATDMA - 64QAM37.50033200000
323700000ATDMA - 64QAM33.00026400000
OFDM/OFDMA Overview
Channel IndexStatelin Digital AttDigital AttBW (sc's*fft)Report PowerReport Power1_6FFT Size
0DISABLED0.50000.00000.0000-inf-1.00004K
1DISABLED0.50000.00000.0000-inf-1.00004K

 

 

I Plan to Stick Around
Posts: 54

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

@RogersDave

 

Not too sure what is going on, but I am getting either socket errors or the following speeds this afternoon.   Have rebooted twice, have not had a problem all week: EDIT:  Noticed two Rogers trucks at the end of street running a temp line to someones house, would that affect me?

 

Coda-4582 12.21.16..JPG

I'm a Reliable Contributor
Posts: 580

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

After a couple of days testing modem ports 1, 2, and 3 on the CODA-4582, I have concluded that all 3 ports are effected by the 2.4GHz issue. Switching to any of those ports (in my case) has not seemed to fix the issue, however rebooting the modem has temporarily  fixed the issue. We pretty much have to wait for a implementation by Rogers and Hitron in order to fix this problem. 

I'm a Regular
Posts: 859

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

What happens when disabaling 2.4 does it fix it ?