Rogers Community

Hwaiting · 12-18-2022

Hi all,TL;DR - my OFDM levels and correctable codewords seem high. Would removing the amp + splitter put the OFDM levels more in range even if it may cause QAM levels to suffer? The cable that enters my home through the electrical box in the basement...

Hwaiting · 10-12-2022

Hi all,I'm trying to figure out if it's possible to use my USB HDD (WD My Book) like a NAS with my XB7 and a spare router with USB ports. When I had the CODA modem, I used it in bridge mode and my own router had USB ports so I was able to just connec...

Hwaiting · 09-04-2022

Hi everyone, I upgraded to Ignite 2 weeks ago and have been using the XB7 in normal configuration with a single SSID for both 2.4 and 5 GHz networks. I've been popping into 10.0.0.1 periodically to check on my devices to see what's connected to which...

Hwaiting · 08-14-2022

Hi everyone (not sure if this should be in Internet or Ignite TV, it's a bit of both)I'm having my legacy Internet/TV converted to the Ignite platform this week by a tech. My current configuration is with the CODA-4582 modem in bridge mode connected ...

Hwaiting · 12-27-2021

Hi, My phone line is with Bell and use to be supplied using traditional phone wiring. It started having some probs (they said the wiring leading to the house was shorting) and since I had a fiber drop coming to the house, they switched my phone serv...

Hwaiting · 02-01-2023

Ugh, I'm starting to get the lip sync issue all of the sudden after my first 5 months of Ignite with no problems.No changes were made to hardware or cables. The box is connected directly to the TV (no AVR/soundbar).Does anyone know why I'm seeing it ...

Hwaiting · 10-15-2022

Just thought I'd update my post and share in case someone else ends up encountering something similar.I haven't had any problems since I disconnected my Chromecast Ultra. About a week ago I did try connecting the Chromecast Ultra again. Sure enough a...

Hwaiting · 10-15-2022

After some Googling and Youtubing, I was able to get my USB hard drive on the network using my old router (Netgear R7000).I put my R7000 into AP mode (I turned off the radios since I didn't need it broadcasting). Then I hooked up the USB HDD to the R...

Hwaiting · 09-08-2022

What you describe sounds like an HDMI issue but it's odd that it is happening only when you connect your PC to the modem. I know you checked the secureness of the HDMI cables but do you happen to have different HDMI cable that you can swap and/or use...

Hwaiting · 09-05-2022

Hi @-G- ,My modem is located centrally on the 2nd floor. So it's been almost a day and the majority of my devices are still connected at 5 Ghz so that's a good sign so far.It's funny you mention how there were previous XB7 problems when one device wo...

Rogers Community

User Statistics

User Activity

Signal levels and setup question, also QAM vs OFDM

How to connect USB HDD to network

5GHz network goes down on XB7

How are the new modems for Wi-Fi coverage compared to 3rd party routers?

Can I keep Digital TV and have only Internet and Home Phone be Ignite

Re: Ignite TV - Frustrating Audio Delay!!!

Re: 5GHz network goes down on XB7

Re: How to connect USB HDD to network

Re: TV flickering slightly only when computer has ethernet connection.

Re: 5GHz network goes down on XB7

Re: How to connect USB HDD to network