Can report for roughly 3 weeks from this post my connection has been flawless since joining the trial modem firmware on 188.8.131.52. However, over the past few days I have noticed some noticable ping spikes and what is looking like my issue I had previously in the early stages again.
I've noticed that OFDM/OFDMA has been enabled again. I'm not sure if any other changes were made, but this is the only change that I can visibly see and I have not made any changes myself.
We have new code for our CODA-4582 (184.108.40.206) which we are ready to share.
The primary fixes this build delivers are:
Please let us know your experience on 5GHz, any changes/improvements you see.
We will look to roll this code out in the next couple of days.
Received 220.127.116.11 last night. Only configuration change I see is the upgrade enabled USB Sharing, where it was disabled before.
I got the new Firmware as well!
|10||05/10/2021 23:59:53||69010100||Notice||SW Download INIT - Via NMS|
|11||05/11/2021 00:01:02||69011100||Notice||SW download Successful - Via NMS|
|Port ID||Frequency (MHz)||Modulation||Signal strength (dBmV)||Channel ID||Signal noise ratio (dB)|
|Receiver||FFT type||Subcarr 0 Frequency(MHz)||PLC locked||NCP locked||MDC1 locked||PLC power(dBmv)|
|Port ID||Frequency (MHz)||Modulation||Signal strength (dBmV)||Channel ID||Bandwidth|
|Channel Index||State||lin Digital Att||Digital Att||BW (sc's*fft)||Report Power||Report Power1_6||FFT Size|
Also have .37 on 1A hardware. have 500 service and usually speedtest shows slightly above. first thing this morning speed was ~200 and has improved slightly but still only getting 300. have also had 3 occurrences of having to set wifi up again. did reboot router 3 times today only showing as stated moderate improvements between reboot 1 and 2.
getting terrible speeds 10 Mbps after the firmware upgrade. have power cycled. Get gigabit speed after the power cycle but after a few hours it becomes 10 mbps again.
I had requested to get off the trial but i keep getting pushed beta firmwares.
Please take me off the beta testers!
@roy86 10 Mb/s down or up? Does it ever stabilize where it should be?
Can you post your signal levels from the DOCSIS WAN tab. Select the Downstream Overview, all the way down to the bottom right hand corner of the OFDM/OFDMA Overview, right click .... Copy. In a new post, right click .... Paste. That should paste in the entire table as it appears in the modem's user interface.
It would be interesting to see two views of this, one just after you power cycle the modem, and one when you are seeing very slow data rates.