Looking for some support since Technicians are not doing home visits right now.
I have a keypad, (not Rogers Equipment), that is by my entry door. About 3 weeks ago it started beeping randomly and doesn't show when the system is armed or disarmed.
I called the call centre and went through the trouble shooting and was told it is out of sync with the system. They had me go through the steps to recognize the key pad from the Rogers touch pad, but it would not find the key pad.
Any help would be appreciated.
*** Edited Labels ***
Welcome to Rogers Community Forums! 😀
Thank you for posting your concern in the Community. It can be bothersome when the keypad beeps randomly and not able to use it to arm/disarm the system.
As tech support suggested, it seems like the keypad is out of sync with the Smart Home Monitoring system. It may require a reset of the alarm panel.
@Gdkitty - any input on this situation?
Thoughts anyone? Happy to provide additional details about the non rogers keypad if that would be of any help.
We'd like to take a closer look at this for you and see what options we have available to get this matter resolved for you. Please send a private message to @CommunityHelps so we can get started.
Not familiar with our private messaging system? No worries, Click Here.
We look forward to hearing from you!
My keypad started doing the exact same thing. Even the time goes out of sync by 10-20 mins.
I can imagine how annoying it is having the keypad beep randomly or become out of sync with the rest of the system.
You may need to power cycle the alarm panel where your non-rogers keypad and sensors are wired up to. The panel will have a large black backup battery with a positive and negative connector at the top, you just need to remove the leads connecting to the positive and negative connector to disconnect the battery.
The panel also receives power via an adapter that is plugged into a wall socket or it may be hard wired to your home. If there is no power adapter connecting from the panel to a power socket then you'll need to find the circuit breaker switch that powers the area where the panel is wired and switch it to the off position to reset the panel and keypads. Please take a look at the keypad and ensure there are no lights on the display before reconnecting the battery and then the power supply.
If you have any trouble following these steps please feel free to send a private message to @CommunityHelps so we can try to assist you further.
Not familiar with our private messaging system? No worries click here.