Modem keeps rebooting

[Easton638]

Hello,

My modem is the CODA 4582 and today i have noticed it rebooting at least 5 times in the span of 4 hours which becomes annoying as it takes a couple of minutes to get back up and running again

These are the DOCSIS wan signals from the modem portal, is there anything i should be concerned about?

Downstream Overview

Port ID	Frequency (MHz)	Modulation	Signal strength (dBmV)	Channel ID	Signal noise ratio (dB)
1	603000000	256QAM	-6.100	9	40.946
2	849000000	256QAM	-7.700	2	38.605
3	855000000	256QAM	-8.400	3	38.605
4	861000000	256QAM	-9.100	4	38.605
5	579000000	256QAM	-6.100	5	38.983
6	585000000	256QAM	-6.400	6	38.605
7	591000000	256QAM	-6.100	7	38.983
8	597000000	256QAM	-5.900	8	38.983
9	303000000	256QAM	-7.500	1	38.605
10	609000000	256QAM	-5.800	10	38.605
11	615000000	256QAM	-5.600	11	38.983
12	621000000	256QAM	-5.700	12	38.983
13	633000000	256QAM	-5.600	13	38.605
14	639000000	256QAM	-5.700	14	38.983
15	645000000	256QAM	-5.800	15	38.983
16	651000000	256QAM	-5.300	16	38.605
17	657000000	256QAM	-5.100	17	38.605
18	663000000	256QAM	-5.100	18	40.366
19	669000000	256QAM	-5.100	19	38.983
20	675000000	256QAM	-5.100	20	38.983
21	681000000	256QAM	-5.500	21	38.983
22	687000000	256QAM	-5.900	22	38.983
23	693000000	256QAM	-5.700	23	38.983
24	699000000	256QAM	-5.700	24	38.983
25	705000000	256QAM	-6.000	25	38.983
26	711000000	256QAM	-5.900	26	38.983
27	717000000	256QAM	-6.000	27	38.983
28	723000000	256QAM	-6.800	28	38.605
29	825000000	256QAM	-8.000	29	38.605
30	831000000	256QAM	-7.200	30	38.605
31	837000000	256QAM	-7.400	31	38.605
32	843000000	256QAM	-8.000	32	38.605

OFDM Downstream Overview

Receiver	FFT type	Subcarr 0 Frequency(MHz)	PLC locked	NCP locked	MDC1 locked	PLC power(dBmv)
0	NA	NA	NO	NO	NO	NA
1	4K	275600000	YES	YES	YES	-8.200001

Upstream Overview

Port ID	Frequency (MHz)	Modulation	Signal strength (dBmV)	Channel ID	Bandwidth
1	30596000	ATDMA - 64QAM	34.000	1	6400000
2	38596000	ATDMA - 64QAM	37.500	3	3200000
3	23700000	ATDMA - 64QAM	32.750	2	6400000

OFDM/OFDMA Overview

Channel Index	State	lin Digital Att	Digital Att	BW (sc's*fft)	Report Power	Report Power1_6	FFT Size
0	DISABLED	0.5000	0.0000	0.0000	-inf	-1.0000	4K
1	DISABLED	0.5000	0.0000	0.0000	-inf	-1.0000	4K

*Added Labels*

[Gdkitty]

While technically still within spec.. your signal levels are WELL on the low side.

You want to be as close to 0 as possible, and your almost down to -10 on some channels. 

I would call tech support and point this out, and get them to send a tech out to check things out and tweek things to get it more in line.