Internet
Got questions about your modem, router, speeds or WiFi?
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

ASUS Wireless AX3000 Dual-Band Mesh Wi-Fi 6 Router (RT-AX58U/CA)

Hey everyone, I'm going to be getting 500 ignite internet (most likely, I think this is enough for working from home, gaming, streaming, etc) and wanted to know what everyone thinks about the SUS Wireless AX3000 Dual-Band Mesh Wi-Fi 6 Router (RT-AX58...

kuruczpa by I've Been Around
  • 542 Views
  • 1 replies
  • 0 likes

Network setup using both XB6 dual ports?

Hello, I'm trying to get both ports on the back of the Arris XB6 to see each other over network? Is this even possible??? I would like to be able to access my movie collection from the DS415 from port 2 over to my Nvidia shield or Mede8er 800X3D box....

vincez28 by I've Been Here Awhile
  • 898 Views
  • 6 replies
  • 0 likes

Asus AX88U - WAN Connection: ISP's DHCP did not function properly

Hi, I recently installed a new AX88U router at home and today internet access went down for a few minutes. When I checked the log, I noticed this error in router logs and this matches with the time when internet access had gone down: Nov 21 12:16:57 ...

vikas-arora by I Plan to Stick Around
  • 3266 Views
  • 11 replies
  • 0 likes

Configuring IPv6 on Orbi Mesh

Hi, I just upgraded my Netgear R7000 to the Orbi AC3000 ts week. My old router was running a Merlin variant that makes it an ASUS router. The ipv6 configuration is seamless. Now that I have the Orbi, I could not configure the ipv6 properly. Does anyo...

jseller by I Plan to Stick Around
  • 1821 Views
  • 2 replies
  • 0 likes

Setting Up Separate Router

I have a CODA in the basement where its 4 ports go to 4 ethernet ports upstairs. I also recently bought an Asus router that I would like to use instead of the CODA. Would it be possible to use the Asus at one of the ethernet ports upstairs while stil...

Sankeeth by I've Been Here Awhile
  • 3022 Views
  • 3 replies
  • 0 likes

Resolved! Ignite 500U: CODA-4582U, good; bridged to RT-N66U, not so good.

Summary:- Until yesterday I had Ignite 100U and I was getting ~130Mbps *wireless* with the CGN3 gateway bridged to the ASUS router.- Today I have Ignite 500U and after straight-swapping the CGN3 with a CODA-4582U I'm getting ~140-170Mbps *wireless* w...

eljay by I Plan to Stick Around
  • 2379 Views
  • 4 replies
  • 0 likes

Hitron CODA - 4582 - No IP Pass-through Option?

Hello, I have Hitron CODA - 4582. I have connected an additional Asus router and I want to access NAS over the internet through this new (Asus) router. But it wont allow me because the new router is assigned internal IP and is not visible externally....

z_mak by I've Been Around
  • 1686 Views
  • 1 replies
  • 0 likes

Resolved! Managed hubs/switches

I currently have a simple Cisco 16-port hub between my Rogers Hitron Cable Modem and the household LAN. I believe I could upgrade this hub to a device which would have the ability to report to me (to my system) the bandwidth usage of each device conn...

Philip144 by I Plan to Stick Around
  • 4244 Views
  • 13 replies
  • 0 likes

Resolved! Which port WAN or LAN

I have the CGN3ACSMR and ASUS RT-AC68U (set up in Access Point mode.) From the CGN3 I have ethernet cables going to (1) the RT-A68U (2) a switch for desktop computers & MyCloud and (3) another switch for the rest of the house. So far, so good. Howeve...

mrbrimi by I Plan to Stick Around
  • 4439 Views
  • 3 replies
  • 0 likes