@BryanV What you're describing is not the old Atlas URC1056BO4 5-button remote, the subject of this thread, now discontinued, but the new CHAMPION PLUS URC2125B0-BB remote, which replaces it. See this thread.
no volume/video source
Everything worked fine last night. Tonight I cannot control the volume on my 5 button converter, nor can I switch HDMI modes to watch Apple TV . I used to hit "tv" then video source to change HDMI modes - now nothing happens-cant even get the screen to appear. Volume/mute don't work either. All other functions appear fine. I have tried reprogramming to no avail. Thoughts?
When you press buttons on the remote, do the lights of the appropriate devices flash on the top of the remote? (CBL, TV, etc?)
If you get a number of flashes, then the batteries are low.
You can check if the remote is sending IR signals by pressing a button and viewing the sending part of the remote with a digital camera or your phone. The light is invisible to our eyes but can be seen with cameras.
yes the lights work. i used the camera to test the IR signal lights up and that does work. the Remote control works on TV but NOT on the cable box It just quit working.Not dropped , did not get wet. Nothing it just stopped working.
@PVonier2018 : Have you pressed the CBL button at the top of the remote? Does it light up when sending cable commands?
Check out the following link for the remote:
Here's the operating manual for the remote under discussion in this thread. If you have a different remote, you can download the manual using the link above:
You can clear custom programming with the following procedure:
The Atlas OCAP 5-Device Remote Control with Learning contains a Custom Programming Reset program. You can use it to remove all custom programming, except your setup codes and reassigned device keys.
IMPORTANT: Executing this program will erase all cus- tom settings for Volume Lock, Learned Keys, Tune-In Keys, and Channel Lock. However, your device programming remains.
1. On the remote control, press and hold SETUP until the last-selected device key blinks twice.
2. Enter 9 8 0. The last-selected device key blinks twice, pauses, and blinks twice again to confirm that all custom programming is cleared.
You may then need to reprogramme the remote for your TV, etc.
You can take the remote back to a Rogers store. They will swap it for free, however, you will likely be provided with the new Champion IR/RF remote, which has some differences discussed in the following thread:
@PVonier2018 As @57 mentioned, if you can't get your remote working, Rogers will replace it for free. They did that for me, but it was the new IR/RF one, which is very nice, but lacked a couple of functions the old 5-button one had. I managed to screw it up by following instructions in another thread here. I ended up buying a new Atlas 5-button remote off eBay for about $22 including shipping.
It is absolutely ridiculous that Rogers makes a product or uses a product that you can't program it should it become unstable
@PVonier2018As @57 mentioned, if you can't get your remote working, Rogers will replace it for free. They did that for me, but it was the new IR/RF one, which is very nice, but lacked a couple of functions the old 5-button one had. I managed to screw it up by following instructions in another thread here. I ended up buying a new Atlas 5-button remote off eBay for about $22 including shipping.
. The older system was MUCH BETTER
. The older system was MUCH BETTER
That is absolutely true. replacing a product with a new version that does not include ALL the functions of the old one is inexcusable. The NAVIGATR cable TV interface is a prime example. It not only missed several useful functions the previous interface had, it introduced a lot of glitches that users are still complaining about.
I have entered all the LG TV remote codes individually (numerous times) on my URC1056B03 remote in an effort to get even minimal functionality with a new LG OLED65B7P TV (awesome TV btw). None of the codes produce any functionality at all.
I have also used the dumb code cycle function with over 500 code entry presses, patiently timed, with zero functionality achieved on the remote for this TV.
Anyone have a code that works on this remote for this TV?
Rogers, can I get an updated remote that supports both the Nextbox 3.0 and newer LG TVs?
Thanks anyone who can assist.
Reigning heavyweight world champion Deontay "The Bronze Bomber'' Wilder takes on his most dangerous challenger as he defends his WBC title in a rematch against once-beaten Cuban slugger Luis "King Kong'' Ortiz.