1. I press the mode button (tv) 2. I press and hold setup until tv blinks twice. 3. I begin to enter the 4 digit code. But when I do this, it reverts back to cable and tries to change the channel. Even with the box off, the cable button lights up during number entry.
Thank you for your post! Being able to control your TV with your digital terminal remote is key.
Please try the following steps to program your Rogers Champion remote:
Press and hold SETUP until LED blinks twice.
Press TV mode key.
Press and hold OK.
Release key when TV turns off.
Press the POWER button to check whether it turns on the TV.
Since the Rogers remote control is a universal remote, you can program it for other components by repeating the steps above and substituting the TV button with the respective device button (DVD, Audio, etc.).
It's disappointing to see that you were unable to get the remote programmed for your TV using the steps and the codes outlined on the website. =(
The manual scanning option can take some time to find the right code, how long did you attempt this for? While the universal remote is able to control most devices not all devices are supported. If after exhausting the manual code scanning option the remote still cannot control your TV it may not be compatible.
I attempted several times to do the automatic scan by holding OK button while the tv light flashes quickly as it cycles through codes. Nothing happened.
I also attempted to enter the manual codes from URCsupport web site: 2434 and 3183. When i try to enter those manual codes, for some reason as soon as i press a number, it reverts back to cable and tries to change the channel.
I had this remote working fine with my previous samsung tv