I have a panasonic TV, but pairing hte RF feature with a NB3 shouldn't depend on which TV is also on the remote? The TV works fine
Just a heads up - I have never been able to successfully pair an RF remote with my Nextbox 3. If the remote successfully pairs, I should be able to "point" the remote backwards toward a wall (or other obstruction) and have it work...never does for me!
I continue to use my RF remote in IR (standard) mode. Works fine unless something gets in the way (box of tissue, items on table, etc).
Thank you for the information. As a standard practice, our digital boxes are pre-programmed with the URCs, unless the initial settings are changed. Here are the steps on how to pair your remote:-
1. Press the mode key for the device type you wish to setup.
2. Press and hold SETUP until the mode key blinks twice.
3. Using the digit keys on the remote, enter the code 1291
4. Test the remote to confirm that it controls your device as expected.
If the pairing is not successful you can obtain an alternate code here. You'll have to scroll all the way down to Remote Control Setup.
Hope this helps! Please keep us posted.
You seem to be doing everything properly to pair your RF remote with the NB3. The only thing I can suggest is to ask someone else in your residence to try while you read them the instructions. I have found that sometimes a slightly different point of view can make things work.
The "pairing" we are discussing has to do with the RF remote and the NB3, as discussed in the following link. Your post seems to be assuming something else.
"If you have a NextBox 3.0 or NextBox 4K, follow these steps to pair for Radio Frequency (RF). RF allows you to control your NextBox with your remote without line of sight, through a door or a wall.
I apologize for misunderstanding your request as I was under the impression you required steps on how to pair the remote with your TV.
In this case if you are experiencing issues pairing your RF feature, please try the steps listed above by @57.
- Press and Hold the SETUP key + UP ARROW at the same time to put the remote control in pairing mode.
- The CABLE button will continually flash until pairing is completed. Once pairing is successful, the LED under the CABLE key will flash twice."
Please keep us posted on the outcome.
@57 thank you for the clarification.
Ive tried, my friend has tried. No joy. Tried arrow down to unpair, which shows success but pairing just blinks for about 30 - 45 seconds and never works...
Grasping at straws here. Try rebooting the NB3, then pairing when the reboot is complete - say 10-15 minutes after starting the reboot.
Whoops, I see that you already tried that too in post 159. Give it one more try?