@NoChoice1Hold the INFO button on the DTA50 Remote for at least 10 seconds and you'll get the diagnostic screens. The Tuner Status screen has the signal level and signal to noise ratio. The signal level in dBmV should be between -10 and +10, with zero being about optimum. Bigger numbers are a problem. The S/N ratio is good if it’s at about 35 dB. If your S/N is around 30 (or less) though, that could be a source of problems. At least those are the numbers given for regular boxes. But if you call Rogers and get through whe you have this problem, they should be able to check your signal remotely.
Thanks for replying! I just pressed the Info button (at almost 10 a.m.). (Who knew?) Turner Status shows signal-to-noise at 37. The problem is at night, tho, anywhere from about midnight to 5 or 6 a.m. Not in the daytime. I'll check it night, now I know to do that.
Since I have a technician booked for today I'm hoping he can find the problem. Again, thanks for telling me something I didn't know!
Rogers' technician came and went. He did swap the adapter for a new one, and also put in a new cable splitter as I've got 2 TVs and 2 adapters. The TV in the living-room has never been a problem, day or night. It's the bedroom TV I've had problems with at night. Anyway, we'll see if the new adapter fixes the problem at night.
I do get the lobby security camera on the bedroom TV now (only on the living-room TV before), instead of the Rogers' "service interruption" message, so maybe there's hope.
Can't believe there's a repairman who doesn't charge for his expertise! My hat's off to Rogers, especially if the new adapter fixes the problem.
I'm glad a Rogers tech fixed your problem, as far as you can tell so far. The DTA50s are no longer offered by Rogers. I've always had good experiences with Rogers techs fixing my cable problems, redoing connections and replacing splitters no charge. After all, if they can't deliver the service they need to fix it.
So ... the new adapter seems to have done the trick BUT I now get minimal volume from the TV. Even with the volume turned up to maximum, I can barely hear the TV. Always before, maximum volume was needed at night, but I at least could hear the TV. Daytime I turned volume down. I'm not a technical person at all so I don't know: Would the new adapter interfere with the volume or do I have yet another problem?
You can control the volume on the DTA and the TV. Make sure it's turned up on the TV.
In case that was not clear, you may need to use both remotes (TV and DTA) to set the volume properly. Set the volume on the TV say at the half way to 3/4 way point using the TV's remote. Then control the volume via the DTA's remote on the DTA itself. If you hear a lot of "hum", then you may need to lower the TV's volume and increase the DTA's volume or vice versa until you get it just right.
You should also be able to see if the DTA remote is controlling the volume of the TV or the DTA...
How do I do that? I can see volume numbers on my TV screen. Both the TV remote and the Rogers adapter remote show the volume at maximum, yet the volume has not increased.
In that case there could be a problem with the DTA or its setup. In my case the volume bar for the TV volume may not be visible if the picture is zoomed, which is why I asked.
He's back! Irish superstar Conor McGregor makes his return to the Octagon on January 18, and he's kicking off 2020 with a welterweight showdown against the man with the most wins in UFC history, Donald "Cowboy" Cerrone. Returning to action for the first time since October 2018 in the main event of UFC 246, the two-division champion from Dublin known as "The Notorious" one wants to make a statement against Albuquerque action hero Cerrone, who has picked up five post-fight performance bonuses in his last five bouts.