Long ago I had intermittent connection issues with Rogers. My old thread is here:
Since then I moved, and for almost 2 years I've had no issues. Last week, with no changes on my end, I've begun to get intermittent disconnects of the WAN (LAN stays up) through the day. It's usually 1-2 times, and almost always it's after I wake up and begin to use the internet. Sometimes it's also when heavy streaming is taking place (i.e. YouTube on 1 device, and Netflix on another).
When the internet is mostly idle (i.e. overnight) it's fine. But as soon as I wake up and start to put a load on it, the WAN goes down for 1 minute or so. Here's the DOCSIS log (from this morning's disconnect):
It's a Hitron CGN3ACR modem:
Hardware Version 1A
Software Version 126.96.36.199
Any advice would be great. Thanks.
Solved! Solved! Go to Solution.
I'm glad to hear you had such a solid run without issues! Though this intermittent WAN disconnection might seem troublesome it can be relatively simple to isolate :).
Are you able to provide the following information for us so that we can assist further?
Screenshot of your signal levels, found by logging into your modem.
A screenshot of your WAN and LAN uptime after disconnect. This can be found on the Status page of your modems GUI.
Lastly, can you confirm the error message if applicable, when you mouse over your PC's network icon during disconnect? Ex: "Connected - No Internet"
Thanks so much! Looking forward to getting to the bottom of this with you.
@RogersAndy Yes it just happened again now.
I actually included the stream information in the original post, not sure why it's not there now.
Here's the requested screenshots taken with my phone logged into the modem, some info I blanked out just in case:
***Removed images to keep things private***
I put it in an album. Thanks for the help.
Thanks for the updated information, @automaton. If possible, can you delete the image with the logs?
Your signal levels look great. Where things seem to go haywire when you put any type of load on your connection, have you tried factory resetting your Gateway?
Beyond that, If all the connections are secure and you haven't added anything since this started; we'll need to take a deeper look into your signal and your overall area. Please give us a PM @CommunityHelps. If you're not sure how to PM us, you can find out more by clicking, Here.
@RogersTim yes, I deleted all the images. Thank you.
If the signal levels in the area are fine, then I guess the question is more about why it fails to get a broadcast answer (as per the log).
It could be a modem issue. Can I just swap out the modem to try a new one? Mine is a bit old, although I like this specific model.
@automaton if you're going to swap the modem, call the nearest Rogers store before you go there and ask if they have a CGN3ACSMR in stock. While the various CGN3 modem models are close but not identical, the CGN3ACSMR has usually received any updates before any of the other CGN3 models.
You might need to call tech support to generate a work order to swap the modem at the local Rogers store. That has been a recent development but there appears to be no consistency from store to store, as to which requires a work order or ticket, and which don't.
Swapping the modem is one step to determine if this really is a modem issue, or if there's something else going on. Does your current cable installation use a powered amplifier? That would be sitting where the cable enters the home, and would have been installed by the Rogers tech.
WAN dropping for a few minutes multiple times every day:
I have a Hitron Coda-4582 hardware version 1A, software version 188.8.131.52. A few times every day my internet will go out for a few minutes. Checking the status page shows that my WAN uptime is reset after one of these brief outages:
Here are my signal levels:
|Port ID||Frequency (MHz)||Modulation||Signal strength (dBmV)||Channel ID||Signal noise ratio (dB)|
|Receiver||FFT type||Subcarr 0 Frequency(MHz)||PLC locked||NCP locked||MDC1 locked||PLC power(dBmv)|
|Port ID||Frequency (MHz)||Modulation||Signal strength (dBmV)||Channel ID||Bandwidth|
I have already tried swapping out my modem for another one, and the problem resurfaced within a few days. Can someone provide me some help? I am very worried about my internet dropping out during an important meeting during while working remotely.
Thank you for posting your Internet intermittency concern, and welcome to Rogers Community Forums.
I appreciate you including the signal tables in your post; all the levels look fine. The issue may not be related to the RF signal.
If you don't live in an apartment building, you can check the solution post of this thread and also this post to see if the coax cable is securely grounded.
Please keep us posted.