Yes, Discord does mainly use UDP for "voice data transmission"
An excerpt from the developer website states that:
utilize a separate UDP-based connection for voice data transmission. Because UDP is utilized for both the receiving and transmitting of voice, your client must be able to receive UDP packets, even through a firewall or NAT
I ran a test for speeds and this is what I get now:
My signal levels are as follows:
|Port ID||Frequency (MHz)||Modulation||Signal strength (dBmV)||Channel ID||Signal noise ratio (dB)|
|Receiver||FFT type||Subcarr 0 Frequency(MHz)||PLC locked||NCP locked||MDC1 locked||PLC power(dBmv)|
|Port ID||Frequency (MHz)||Modulation||Signal strength (dBmV)||Channel ID||Bandwidth|
|1||23700000||ATDMA - 64QAM||33.250||2||6400000|
|2||38595746||ATDMA - 64QAM||38.500||3||3200000|
|3||30596000||ATDMA - 64QAM||34.750||1||6400000|
|Channel Index||State||lin Digital Att||Digital Att||BW (sc's*fft)||Report Power||Report Power1_6||FFT Size|
I will say that I am on the correct profile and if there are any speed issues it is because of network congestion.
This was my speedtest result Dec 30 around 6:16 am before the fibre cut
I don't think we will really see this speed again unless we get to Docsis 3.1 or until Rogers focuses on fixing their network to what we were getting before the cut.
This was discussed earlier in this thread, but I am still a little fuzzy on it. I have the 100u service. Am I eligible to upgrade my modem from the CGN3ACSMR to the CODA-4582? And if the answer is yes, is it a worthwhile upgrade or should I just leave well enough alone and stay with what I have? I presently have no issues, and I am achieving the expected speeds and performance.
If you have no issues, you might as well wait a bit until all the issues are getting resolved on the new coda ( if you are not interested in beta testing) then it would be the best decision for you.
I was told by Rogers support that I would not be able to get the 4582 when I moved to the 100u plan and that their system would not let them attach that modem to my plan.
I believe Rogers had indicated in their December news release that the 4582 is currently intended for 250u and gigabit customers only.