Showing results for 
Search instead for 
Did you mean: 

FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

Community Manager (Retired)
Community Manager (Retired)

Hello Community,


We are currently offering our users an exclusive opportunity to participate in an upcoming trial of the new firmware for our Rocket Wi-Fi Modem (CGN3ACR, CGN3AMR and CGN3ACSMR) and Rocket Gigabit Wi-Fi Modem (CGN3552 and CODA-4582). For details of this program, please see this thread.


This thread will be used for feedback regarding the firmware.  We've invited @RogersSergio@RogersSyd & @RogersBob from our Networking team to participate in this thread.  Your feedback is very valuable and will be used to enhance the firmware before it is released publicly.


Thank you for your continued feedback and support.

4,921 REPLIES 4,921

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

@Gabandara can you log into the modem and check the Software Version (Firmware) version that is shown on the STATUS page that is displayed when you log into the modem.  Or, do you know already that you are running V4.5.8.22?  If you have requested that version and it is loaded, please have a look at the following post for my post update instructions.  Hopefully that will help if you have V4.5.8.22 loaded now:




Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I've been here awhile
Ok this has been the worst day yet of drop outs. Internet cut out over and over today. I have the firmware and have done a factory reset multiple times still don't see a IPv6 address on the status page. I have tried the modem in gateway mode and bridge mode and niether makes it any better. I have disconnected all Ethernet connections to the router without any change. Any advice on anything else I can try?

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

@New_Man, since I just typed this, it seems appropriate for you as well:


Can you:


1.  Confirm what model of modem you have as seen by the product sticker at the back of the modem.  I would think that its a CGN3XXX variation or possibly a CGNM-3552.


2.  Log into the modem and navigate to the STATUS .... DOCSIS WAN page, copy the downstream and upstream tables and paste those into a post.  The copy and paste process will copy the text components of the tables and paste them into a post, so using a screen capture won't be necessary.


3.  Please read my post regarding the use of Pingplotter to monitor the modem to CMTS cable path to look for anomalies in the performance of that path.  My personal opinion is that along with the modem, this is the most critical part of the cable internet system.  Get this part right, along with the modem, and your internet performance should be rock solid.  Easy for me to say as an armchair quarterback, but, with a little persistence it can be done.  If you can post an image from pingplotter as is indicated in that post, between the signal levels and the image, hopefully we can start tracking down the cause of the problem with the internet service:


Please send me a pm, or to @RogersDave a copy of the line from your Docsis Events page that contains the CMTS-MAC=XX.XX.XX.XX.XX.XX and CM-MAC=XX.XX.XX.XX.XX.XX addresses.  Its possible that IPV6 is not enabled for your CMTS.  @RogersDave would be able to determine that.  To send a pm, click or select my name or Dave's name in the link to go to the public page.  On the right hand side a a link titled "Send this user a private message".  Select that to go to the message composition page, fill in the title, details and hit send.  Watch for a number overlaying your personal icon at the upper right hand corner when you're logged into the forum.  Select the icon to bring up the next menu, then the envelope to drill down to the inbox. 


The rest of my earlier post is located here:


If you're interested in looking at your wifi and house structured wiring, have a look to see if that post can help.

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I've been here awhile

Thanks for the new firmware. It's been more than a week now and no reset has been required in bridge mode. It has only lost the WAN connection once, but recovered it by itself in a few minutes.


I just have one question: the original firmware version was and in a previous post you said that a "factory reset" would be required for the upgrade; I haven't done any and things seem to work fine with ... should I still do one, or not?

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I plan to stick around

So the tech was here today and found that the drop that was susposed to have been replaced was only half replaced. All lines are underground here. I am speechless. Why only replace half a drop and join it. That's just askin for trouble


Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

@Vlad_D I would still recommend a factory reset as that jump from .14 to .22 is a pretty big.  Running the factory reset will ensure that IPV6 works properly on the modem and that your modem throughput is consistent.  I've seen some interesting results where the reset had not taken place.  There was an IPV6 address on the modem but IPV6 did not work properly and the speedtest results were inconsistent.  For those reasons I recommend a factory reset. Moving from something like .21 to .22, not a big move, but from .14 to .22, yup, thats a big move.  

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

@Mythen we have underground cables and our Rogers cable has been replaced twice in the last three or four years.  Previous to that, the cable that was in place had been there for a number of years before dying one day.  Replace the cable and we were back in business.  Not a big deal to replace an underground cable.  A bit of a hassle, but not a big deal.

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I've been here awhile

I did the factory reset, as suggested, and reconfigured the modem in bridge mode. The internet speed definitely improved: Rogers speed test went from ~50Mbps to a bit over 100Mbps (I'm on a 100u plan).


On a different note, the "Self-Install" greeting page is annoying and buggy:

  1. If the modem is not connected to Rogers, you are stuck to this page, without any way to get to the admin pages!!!

  2. Why should the user be forced to set up WiFi just to disable it afterwards ...

  3. It makes the user fill in a "WiFi pasword" with just a few charactes and it uses it as admin password as well, without giving you any hint for this (it took me a while to figure that one out) ... because it is short (as an admin password), the user would/should have to change the WiFi password(s) again (if WiFi is desired).



  1. Put on those "Welcome" pages a button/link going directly to the admin pages ("Advanced setup", or similar), wether the modem is connected to Rogers or not !!!

  2. Do not mix the admin and WiFi passwords! Leave the WiFi password field for WiFi (long password, including spaces) and leave the admin password to "password", as documented (or put a separate page/field for the admin password setup)

  3. I might miss something, but this is the first time I find a WiFi password setting field (now I'm talking about the admin pages) that doesn't allow spaces! If this isn't some standards specs I'm not familiar with, please fix those password entry fields.

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I've been here awhile

Thanks Rogers Dave, a man of his word let it be known.

Chiming in after almost a week of getting Dot 22.

Didnt see any improvment until two days later, did 3 factory resets to no avail.


Snippet from Docsis event log showed

09/15/16 14:37:35
SW Download INIT - Via NMS
09/15/16 14:43:20
SW download Successful - Via NMS


Then sometime after 1115 PM Sept 16 the packet gods lined up and said the man has suffered enough give him his 250 down and be done with it.

Tech was scheduled on the 17th at 10am tried to cancel but never happened, heard them banging on the wall outside and long story short.:A VOIP AMP was installed inside to tune the gain numbers to spec despite performance improvement already evident.

Now have a new ganglia that doesn fit inside the wiring cabinet anymore.


Getting the occassional drop and you can still set you atomic clock to the cycle of spikes in latency in ICMP V6Packets to the CMTS.


Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I've been here awhile



I'm connected to a Casa CMTS with a CGNM-3552 running the firmware and have Gigabit internet.


This morning around 9am I got the fastest test speeds for me of 924 down and 34 up.  I've never gotten a faster upload though and have an open ticket for that (but it was in the 9 range before recent maintenance).


In my test config, I'm directly connected to my PC with no router and with the modem running in bridge mode.


I tested my VPN performance right after the above test result was obtained.  My issue is that the VPN performance is horrible with between 9-11 down and ~32 up.  As the CTMS gets loaded throughout the day, the VPN peformance gets even worse especially on the download side.


I also tried connecting the VPN via TCP instead of UDP but it had horrible latency and jitter although download improved about 30% while upload was reduced by about 90%. 


But in both instances, the VPN connection seemed slow and laggy.


Q1) Is anyone else experiencing such unsatisfactory VPN performance with this hardware?


Q2) Is there anyway to configure around the VPN performance issue?


Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

@GC9013, have a read thru the following DSLReports thread.  It might answer some of your questions:



Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I've been here awhile

@Datalink thanks for the reference but I have already read that thread and nothing in there really helps since I don't even get 25 down.


Also the thread is 3 months old and I was hoping for a resolution or at least a progress report about the issue.



One other thing, I also have a much slower connection through a different provider  and even running the VPN through my (old) router, I get more consistent speeds that are 88-94% of the rated speed both down and up and it is more responsive.


Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I plan to stick around

@RogersDave wrote:

@Triple_Helix wrote:

@RogersDave anything new coming or is this beta becoming final?




Daniel Smiley Wink

Hi Triple_Helix,


Firmware is schedule for deployment on CGN3ACSMR in the coming days. A test pool of subscribers were upgraded last week and if everything went well, the decision will be made today to proceed with large scale deployment.


The decision will be made after this deployment for other models.




Software Version4.5.8.22


Downstream Overview
Port IDFrequency (MHz)ModulationSignal strength (dBmV)Channel IDSignal noise ratio (dB)
Upstream Overview
Port IDFrequency (MHz)ModulationSignal strength (dBmV)Channel IDBandWidth
123700000ATDMA - 64QAM48.75036400000
230596000ATDMA - 64QAM48.75026400000
338596000ATDMA - 64QAM48.75013200000


Anything newer then this? You say Firmware





Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I plan to stick around
I disabled IPv6 and the speed went up. Still a maximum of 530mbps off peak on a wired gigabit connection. I tried Open DNS but it's slower. I see 16AQM upstream instead of the 64AQM everyone else posted. I ask the tech about it and he said don't worry about it. Meanwhile, I can't get more than 20mbps upload 😞

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I plan to stick around

Anyone else not able to connect to the router page when they're in bridge mode now? I'm currently bridging to a R7000 and as of this morning I cannot log into

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I plan to stick around
I have the same router (R7000) and I can access the modem via

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I plan to stick around

@RogersDave any updated news on this? and for which Hitron modem/routers?




Daniel Smiley Wink

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I've been here awhile

Just a quick note to confirm that the upgrade to competely resolved issues with Airprint /Bonjour for all my "idevices".  No ill effects to report.  Thanks all.



Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I plan to stick around

Does 22T3 address the issue of IPv6 not working on this site.


This has been up and down for me ever since I got the on .22 trial firmware.


i'm still getting 4/20 when I was getting 19/20 previously.


My router shows that its pulling all the IPv6 DHCP info from rogers but IPv6 seems to be down for me.

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

@Makaveli99, run a factory reset on the modem.  I've seen an example where a CGN3ACSMR was updated but a factory reset wasn't run.  The end results were just as you are seeing now.  You have an IPV6 address but IPV6 testing fails.  So, run the reset and confirm if that cures the situation.  I've also seen flaky results from  So, I usually refresh that page a few times to ensure that I get consistent results from test to test.  

Re: FEEDBACK - Rogers Rocket Wi-Fi Modem Firmware Trial

I'm a senior contributor



I am curently on (September 15, 2016) - Issues identified, firmware on hold


any idea when the issues will be solved ?

and should we expect that after the resolution of these issues, it will be available to all beta testers in the forum?