Can you tell me what specific model of Linksys router you have and the connection path to the Rogers 3825. I know that the 3825 will actually run at 150 Mb/s, but Rogers won't allow that speed on that device. If you wanted to check the signal levels, you will have to kick the 3825 back into gateway mode, and return to Bridge mode if that is what you wanted to do.
Where roughly are you located.. sometimes the SERVER you choose, can make a BIG difference.. speically with routing.
EG: Rogers routing, in Waterloo, goes straight to TORONTO.. so if you were to speed test a waterloo location, it actually goes from waterloo, to toronto, then back to waterloo 😛 Which would slow down the speeds.
Give the ROGERS one a try.
THis will check the speed, without it leaving the rogers network. Is this a good indecator of what speeds you'll get on other sites? No.
But it will at least check the POTENTIAL of the line... that at least OUT of your house, you are getting the apropriate speed.
Being on the 30/5 package, and the cisco router.. you shouldnt really have to worry about the router being a bottleneck, if it isnt gigabite ports, etc.
Give the tests a try on wired... in the bridged setup, and through the linksys router.
Worth a try, to RESET the gateway, back to gateway mode, and plug directly into there, and try again.
JUST to see if the router, is being the bottleneck at all.
I am running the 30/5 at home, and get the speeds no issue.
Mind you, i am paying for the CGN3 modem (different modem)
Hello, I can see what IP address Rogers has assigned to my router but I am unable to access the router outside my network VIA the internet using that IP address to get to the login page. Is there a setting I need to change? Where is this Enable Remote access option? is it disabled by default and would that be the only thing I need to change to allow me to log into it from outside my home? Thx
I need to be able to access the ip of one of my PC's on my lan from outside.
if I don't turn that remote option on do I only need to turn on port forrarding in the router and direct a port number to a specific local ip address?
how do I then connect to that PC? http://routerip : portnumber ?
I used to be able to access my router by going to File Explorer and then Network, but now it doesn't show up, only the other devices (e.g. printer, other computers that are online, etc.) How can I access the router so I can change some of the settings (I need to add another device access to the network)?
I wonder if the router address isn't being properly used for some strange reason. Try this. Open a command prompt and type in:
When the data comes up look for the Default Gateway address. Type that address into the address bar in your web browser, and it should take you to the login page for the modem.